Interface confirmation Check whether there is an EtherNet interface on the backplane of the laser, as shown in the following figure (taking single-mode as an example): If you can see the EtherNet interface, take a network cable, insert one end...

Common faults and solutions of laser cutting machines Cutting and perforating technology Any kind of hot cutting technology, except for a few cases where it can start from the edge of the board, usually must pass a small hole in...

Common faults of laser cutting machines and solutions Does the laser cutting machine start to alarm? Whether the water pipe is turned onCheck whether there is water in the water tankCheck whether the water pipe of the water tank is...

what industries can laser cutters be used? Nowadays, China’s industry has slowly risen, and the metal processing industry can be seen everywhere, and as the global manufacturing center shifts to my country, the annual growth rate of the market demand...

Laser cutters work better, faster and clearer than other cutters. Compared with the traditional cutting process of oxyacetylene, plasma and so on, laser cutting speed, narrow cut, small thermal impact area, good vertical edge of cut edge, smooth cutting edge...

How to Identify The Fiber Laser Cutting Machine Good or Bad？ General, the customers choose the optical fiber laser cutting machine mainly because of Fast speed of optical fiber equipment, low cost and maintenance free. The main considerations for choosing...

How to handle the burr of laser cutting ? How the Laser cutting technology deal with the burr problem, some customers in the use of laser cutting machine processing of sheet metal workpiece, the effect of cutting out workpiece is...

Fiber laser cutting machine VS CO2 laser cutting machine Fiber laser cutting machine who has been able to gain a firm foothold in the market and gradually replace the traditional cutting process is due to its unique advantages in all aspects....