Plasma cutting machine torch can not positioning

Have you encountered the problem that Plasma cutting machine torch can not positioning?

There usually have 2 way of plasma torch positioning:

1.Shield cap positioning

2.Anti-collision device positioning

An Indonesian customer’s gantry plasma cutting machine adopts protective cap positioning due to problems with anti-collision positioning;
He was unable to cut because of the water in the cutting torch and the short circuit when the water entered the cutting torch. Hongyuda raised the alarm and was unable to cut. Remove the water in the cutting torch to cut.

It is better to use anti-collision positioning normally.

Leave a Reply

Your email address will not be published. Required fields are marked *