Common faults and solutions of laser cutting machines 2

Cutting and perforating technology Any kind of hot cutting technology, except for a few cases where it can start from the edge of the board, usually must pass a small hole in the board. Previously, on the laser stamping compound machine, a punch was used to punch a hole, and then a laser was used […]

Common faults and solutions of laser cutting machines

Does the laser cutting machine start to alarm? Whether the water pipe is turned on Check whether there is water in the water tank Check whether the water pipe of the water tank is skimmed or there is an object pressing the water pipe, so that the water pipe does not flow. Check whether the […]